Iron-A-Way NE421AU Guía de instalación descargar pdf (Pagina 4)

ELECTRICAL INSTRUCTIONS

ALL ELECTRICAL WORK MUST BE DONE IN ACCORDANCE WITH ALL APPLICABLE ELECTRICAL CODES.

WARNING: TURN OFF POWER AT SERVICE ENTRANCE BEFORE INSTALLING, WIRING OR SERVICING

THIS PRODUCT.

Note: Opening in the top of the ironing center cabinet for the electrical supply wire is located 2 1/4" on center

from left side of cabinet and 2 1/4" on center from the back of the cabinet.

1. Remove the two screws from the electrical wireway cover.

Note: Toward the top of the electrical wireway, loose black and white pigtails are provided for hookup to

the supply line.

2. Remove the knockout at the wiring entrance location and install a romex connector where the knockout

was removed.

3. Determine the supply wire is ample to run from the top of the ironing center cabinet to the approximate

location of the electrical pigtails. A free wire length of approximately 48" is recommended.

4. As you are placing the ironing center into its location, feed the free supply wire through the romex

connector attached to the electrical wireway.

5. After mounting of ironing center, connect all power supply wires and ground wires in accordance with

all electrical codes.

6. Reinstall the two screws into the electrical wireway cover. Make sure no wires are pinched when

reinstalling the cover.

001095 04/09

1 2 3 4

Sin comentarios

Iron-A-Way NE421AU Guía de instalación Pagina 4